1001

機床緊急停止

Emergency stop

排查急停故障后，釋放急停開關，報警解除

Remove emergency switch after emergency troubleshooting

1003

計數器計數到達Counter count  complete

工件計數到達設定值，按計數器上的復位鍵，再按系統RESET鍵解除報警

Press the RESET button on the counter and then press the system RESET button to cancel the alarm

1007

電機過載保護

Motor overload protection

檢查電機過載保護開關，并排查對應電機的過載原因，故障隱患排查完畢后，合上過載保護開關，報警將解除Check the motor overload protection switch and check the overload cause of the corresponding motor. After the troubleshooting is completed the overload protection switch is closed and the alarm will be relieved

1008

卡盤未夾緊

chuck is not clamped

確認夾緊卡盤，報警將解除Confirm clamping chuck, alarm will be relieved

1009

回零報警Back to zero alarm

進行回零操作Go back to zero operation

1019

刀具壽命到達End of tool life

請更換刀具并清除刀具計數，按系統RESET鍵解除報警Replace the cutter and clear the tool count. Press the system RESET button to cancel the alarm

2016

潤滑油位低Low lubricating oil level

添加潤滑油Add lubricating oil

2044

進給倍率為零The feed rate is zero

轉動進給倍率開關，使倍率大于零，報警解除Rotate the feed rate switch to make the multiplier greater than zero and the alarm is relieved